Unpacking And Parts Identification - SATO M-5900RV Operator And Technical Reference Manual

Section 2. Installation and Configuration

2.2 Unpacking and Parts Identification

Unpack the printer as follows:
• Place the box upright on a solid, flat surface.
• Open the box and remove any loose items and the first layer of packing
• Carefully lift the printer from the box and place it on a solid flat surface.
• Remove the plastic covering from the printer.
• Remove the accessory items from their protective containers.
• If the printer has been stored in a cold environment, allow it to reach
. NOTE: The following illustrations are representative only. Your printer may not be
Page 2-2
material.
Inspect the shipping container and printer for any signs of damage that
may have occurred during shipping.
room temperature before powering it on.
packed exactly as shown here, but the unpacking steps are similiar.
REMOVE PACKING MATERIAL
SATO M-5900RV Operator and Technical Reference Manual
LIFT THE PRINTER FROM
THE BOX CAREFULLY
PN 9001081
Rev. C