Auto Online - SATO M-5900RV Operator And Technical Reference Manual

Section 2. Installation and Configuration
Advanced Mode
Zero Slash Setting
advanced mode
setup
This setting determines if a zero is printed with a slash or without a slash. This setting can
also be controlled via software commands. When YES is selected, the U, S, M, WB, WL,
XU, XS, XM, XB, XL and vector fonts will have a slash through the center of the zero
character.
To access this setting, perform the following steps:
STEP PROCEDURE
1. .rom the Advanced Mode Setup, press the .EED key to move to the
Zero Slash display.
2. Use the LINE key to step the underlined cursor to either YES or NO.
3. Once the correct setting is underlined, press the .EED key to accept
the setting and advance to the Auto Online display.
Auto Online Setting
This setting determines the mode in which the printer powers up. If the YES selection is
made, the printer powers up in the ONLINE mode and is ready to print. If NO is
selected, the printer powers up in the O..LINE mode and must be manually placed in
the ONLINE mode by pressing the LINE key before it is ready to print.
To access this setting perform the following steps:
STEP PROCEDURE
1. Use the LINE key to step the underlined cursor to either YES or
NO.
2. Once the correct setting is underlined, press the .EED key to
accept the setting and advance to the Vertical Offset display.
Page 2-26
SATO M-5900RV Operator and Technical Reference Manual
zero slash
Feed
yes
Key

auto online

yes
no
no
PN 9001081
Rev. C