SATO M-5900RV Operator And Technical Reference Manual page 119

Special Notes
PN 9001081
Rev. C
1. This command can be used for text and for bar codes.
2. It is effective only for the current data stream.
3. When printing lines or boxes in the same data stream with the Line Feed
command, the Lines and Boxes command should be specified last,
preceding <ESC>Q Quantity command.
4 This command is invalid only if the value specified is zero.
5. The rotation command can be used with this command.
6. Following this command with a <CR> character will allow you to print with
auto line feed. In this case, the print position will be determined from the
value specified in the command and the H value set in the printer. However,
if you specify several H values after this command, the print position will be
determined by the H value last specified. You must redefine the font to be
used after each H command.
SATO M-5900RV Operator and Technical Reference Manual
Line Feed
Section 4. Programming Reference
Page 4-53