Unpacking And Parts Identification - SATO CL408 Operator And Technical Reference Manual

Section 2. Installation and Configuration

UNPACKING AND PARTS IDENTIFICATION

Consider the following when unpacking the printer:
• The box should stay right-side up.
• Lift the printer out of the box carefully.
• Remove the plastic covering from the printer.
• For the CL4XX printers, remove the Front Access Door from its protective
bag and attach it to the printer.
• Remove the accessory items from their protective containers.
• If the printer has been stored in a cold environment, allow it to reach room
temperature before powering it on.
• Set the printer on a solid, flat surface. Inspect the shipping container and
printer for any signs of damage that may have occurred during shipping.
NOTE: The following illustrations are representative only. Your printer may not be
packed exactly as shown here, but the unpacking steps are similar.
CL4XX Packaging
Page 2-2
CL6XX Packaging
9001035 Rev. E SATO CL Series Printers