Printing Test Labels - SATO M-5900RV Operator And Technical Reference Manual

Printing Test Labels

Print Size
STEP
3.
4.
PN 9001081
Rev. C
PROCEDURE
If SMALL is underlined, the Print Size message will be displayed. You
must enter the size of the label. The minimum label size that can be
selected is 4 cm (1.6”) and the maximum size is 10 cm (3.9”). Press
the .EED key and then press the LINE key to increment the setting by
1 cm each time the key is pressed. Once the maximum size is reached,
the display will wrap around and start incrementing at 4 cm again.
Once the correct label width is selected, press the .EED key to initiate
the print.
If you wish to pause the printer after it starts to print a test label,
press the .EED key. Press the .EED key again to resume the test
label printing. To stop the test label print, pause the printer and
then turn power off.
LARGE LABEL
SATO M-5900RV Operator and Technical Reference Manual
Section 2. Installation and Configuration
SMALL LABEL
Page 2-37