SATO M-5900RV Operator And Technical Reference Manual page 169

Data Matrix, Sequential Numbering
Special Notes
PN 9001081
Rev. C
Two-Dimensional Bar Codes
Label Set #2
1. The maximum number of <ESC>FX Sequential Numbering commands
that can be used in one job is eight.
2. In the example above, four total labels will be printed.
(<ESC>FX002+005003<ESC>DC00006000). The sequential numbering
will start at position 5 and the three digits "600" will be incremented in
steps of 1. A total of two sets of labels will be printed, the first set of two
labels with the value "00006000" and the next two label set with the value
"00006010".
Label Set #1
1st Label 00006000
2nd Label 00006000
3. The <ESC>Q Label Quantity command must be set for the total number of
labels to be printed. In the above example, the value for the <ESC>Q
command should be 2 sets x 2 labels/set = 4. If, in the above example it
was set to a value of "1", only the first label would be printed.
SATO M-5900RV Operator and Technical Reference Manual
Section 4. Programming Reference
Label Set #2
3rd Label 00006010
4th Label 00006010
Page 4-103