SATO M-5900RV Operator And Technical Reference Manual page 255

EEPROM Clear All
To reset the printer to the factory settings, perform the following steps.
Caution: Resetting the printer will clear all registers.
STEP
1.
2.
3.
4.
5.
6.
7.
8.
9.
PN 9001081
Rev. C
PROCEDURE
Record all current dip switch positions, then place all switches in the O..
position.
Place the DSW2-5 in the ON or up position.
Place the print head in the open position. Keeping both the LINE and
.EED keys depressed, power on the printer.
Upon hearing the audible tone, release the LINE and .EED keys. Place
the print head back in the closed position and DSW2-5 in the O.. or
down position and the display
will change .ROM:
head open
Press the .EED button once. Verify display: "COUNTER CLEAR NON".
Press the LINE button once. Verify display: "COUNTER CLEAR ALL".
Press .EED button to initialize reset. Verify display: ".ACTORY TEST
PRINT.
After a slight pause, (1) blank label will feed out followed by a factory test
print.
Warning: This test activates all the heating elements on the
print head and therefore should be used for testing purposes
only with full width labels to avoid damaging the print head.
Verify that the counters on test print have reset to 0.0 km.
Power O.. the printer and confirm that all switches are in the O.. or
down position.
SATO M-5900RV Operator and Technical Reference Manual
.ACTORY MODE
COUNTER cLEAR
NON
COUNTER CLEAR
ALL
.ACTORY TEST
PRINT
Appendix F. Factory Resets
TO:
See PAGE 7-1
For Example
Page F-3