Initial Avpp Configuration - Avaya 3600 Series Installation Instructions Manual

3.4.1 Initial AVPP Configuration

This process covers the basic initial configuration of the AVPP. However, it is recommended that as much of the AVPP
configuration as possible is done at this stage.
1. Using a DB-9 female, null-modem cable, connect the AVPP to the serial port of a terminal or PC.
2. Run a terminal emulation program such as HyperTerminal or use a VT-100 terminal with the following
configuration:
· Bits per second: 9600
· Data bits: 8
· Parity: None
· Stop bits: 1
· Flow control: None
3. To display the AVPP login screen, press Enter.
4. Enter the default login admin and default password admin. These are case sensitive. The
menu is displayed.
61
5. Use the cursor keys to select Network Configuration and press Enter.
6. Select IP Address and press Enter. Enter the static IP address for the AVPP unit.
7. Select Subnet Mask and press Enter. Enter the subnet mask that matches the static IP address.
8. Select Default Gateway and press Enter. Enter the IP address of the default gateway for the subnet on which
the AVPP is located.
9. Changing the IP address settings automatically puts the AVPP into Maintenance Lock. The AVPP must be reset in
order to set the configuration options.
10.Press Esc. You will be prompted to reset the AVPP. At the reset prompt, press Y (Yes).
11.The AVPP restarts. Following the restart, the AVPP menus can be accessed using
configuration to match the wireless network.
3600 Series Phone Installation
IP Office
Installation: AVPP Installation
NetLink SVP-II System
Telnet to complete
60
15-601082 Issue 06a (21 February 2014)
Page 31