Windows Nt 4.0 Dhcp Server; Verifying The Installation Of The Dhcp Server; Initial Configuration - Avaya 4600 Series Administrator's Manual

Windows NT 4.0 DHCP Server

This section contains details on how to verify and configure the DHCP server included in the
®
Windows NT
Use

Verifying the Installation of the DHCP Server

If it is not, install the DHCP server. If it is installed, go to the section
page 63 and the subsequent sections.
Verifying the Installation of the DHCP Server
Use the following procedure to verify whether the DHCP server is installed.
1. Select Start-->Settings-->Control Panel.
2. Double-click the Network icon.
3. Verify that Microsoft DHCP Server is listed as one of the Network Services on the
Services tab.
4. If it is listed, go to the following section,
the DHCP server.

Initial Configuration

The Windows NT
telephone. A DHCP scope is essentially a grouping of IP devices, in this case IP telephones,
running the DHCP client service in a subnet. The scope defines parameters for each subnet.
Each scope has the following properties:
A unique subnet mask used to determine the subnet related to a given IP Address.
●
A scope name assigned by the administrator when the scope is created.
●
Lease duration values to be assigned to DHCP clients with dynamic addresses.
●
In addition, the DHCP server can assign configuration parameters to a client, and these can be
specified for each DHCP scope.
Setting up the Windows NT
1. Creating a DHCP scope for the IP telephones.
2. Editing custom options.
3. Adding the DHCP options.
4. Activating the new scope.
5. Verifying your configuration.
Each step is detailed in the next five sub-sections.
4.0 server operating system.
®
4.0 DHCP server configuration involves setting up a scope for the IP
®
4.0 DHCP server requires the following steps:
to verify whether the DHCP server is installed.
Initial Configuration. If it is not listed, then install
Initial Configuration on
Issue 5 November 2006
DHCP
63