SERVICE MANUAL
8.13
Seat adjustment standard
8.13.1 Seat / seat frame (without lifter)
Note
This chapter describes how to replace the seat frame on a wheelchair without a lifter or tilt
module. To replace a lifter or tilt module, please follow the procedures explained in chapter
8.13.2.
WARNING: Danger of crushing!
The seat is very heavy. Danger of injury to hands and feet!
● Use proper lifting techniques.
Requirements:
● 6 mm Allen key
● Torque wrench 5 – 30 Nm (or similar)
● Protractor
● Side cutting pliers
● Cable ties
● Wooden block
Note
Take careful note of the exact position of the seat. Mark the position it is mounted in, the angle
and so on. If necessary, make photographs with a digital camera.
Any modification of the adjustment of the seat affects the centre of gravity of the wheelchair.
Removing the seat:
●
Switch the wheelchair off.
●
Remove the front cover and the rear covers, as described in chapters 8.1.1 and 8.1.2.
●
Take exact note of the positions of all cables and the sockets (1) that they are connected to.
Mark the connectors and sockets or take a photograph with a digital camera.
●
Detach all cables from the electronic modules which run from the seat to the chassis.
●
Place the cables so that they do not get in the way when you remove the seat.
98
®
Invacare
- FDX