SERVICE MANUAL
9.5 Fitting the stick holder
Requirements:
● 5 mm Allen key
● Phillips screwdriver size 2
●
Insert the Phillips screw (2) through the borehole of the loop (3).
●
Attach the Phillips screw and the loop to the borehole (1) of the handlebar and tighten the
Phillips screw with a Phillips screwdriver.
●
Loosen and remove the two Allen screws (6) incl. the washers on the lower part of the
backrest hinge (4).
●
Hold the lower mounting (5) with the fastening holes in front of the boreholes of the backrest
hinge.
●
Refit the two Allen screws (6) incl. the washers and tighten the screws.
180
®
Invacare
- FDX