SERVICE MANUAL
8.16.6 Fitting the handlebar
Requirements:
● 4 mm Allen key
●
Loosen and remove the four Allen screws (3) on the plastic cover.
●
Remove the plastic cover (2).
●
Remove the covers on the washer recesses (5).
●
Arrange the handlebar (1) on the back section in such a way that the boreholes coincide with
the tapped holes in the back section.
●
Fit the four Allen screws (4) incl. the washers (5) and tighten the screws.
●
Refit the plastic cover.
●
Refit the six Allen screws (3) and tighten them.
142
®
Invacare
- FDX