®
Invacare
- FDX
8.19
Fixation rings
8.19.1 Replacing a front fixation ring
Requirements:
● 13 mm socket wrenches (two of them)
● Torque wrench 0 – 30 Nm (or similar)
Removing a front fixation ring:
●
Switch the wheelchair off.
●
Remove the front cover and the rear covers, as described in chapters 8.1.1 and 8.1.2.
●
Remove the seat, as described in chapter 8.13 or 8.17.
●
Loosen and remove both of the self-locking nuts (3).
●
Pull the fixation ring (2) up and off of the seat frame (1).
Installing a front fixation ring:
●
Assemble all parts in reverse order.
●
Tighten the screws (3) to a torque of 25 Nm.
●
When installing the seat, pay attention to its heavy weight!
●
When installing the seat, pay attention to the adjustment settings of the seat tilt.
●
Check all functions of the vehicle and go for a test drive.
SERVICE MANUAL
165