Samsung SNP-6320RH User Manual page 96

setup screen
ir Setup
1. Select <ir>.
2. Select each item and set it properly.
• IR Mode:
- Off : Turns off IR LED.
- On : Turns on IR LED.
When using, the daytime/nighttime
mode of the special is set to B/W.
- Day/Night : Turns on/off IR according to the day & night mode.
When the mode is set, the day & night mode of the special cannot be set.
- Sensor : Changes the IR and day & night mode according to the light flux
detected by the light sensor.
When the mode is set, the daytime/nighttime mode of the special cannot be
set.
- Timed : Sets the IR usage time.
When the mode is set, the day & night mode of the special cannot be set.
• LED On Level : LED is turned on when the light flux is lower than the LED usage
level. 1 ~ 90 can be set.
• LED Off Level : LED is turned off when the light flux is higher than the LED usage
level. 11 ~ 100 can be set.
• LED On Time : Sets the time when IR will remain turned on.
• LED Max. Power : Sets the highest brightness of IR.
• LED Power Control: Controls screen saturation caused by a nearby object.
If set to <off>, the LED output is not controlled even when the screen is
saturated.
When you set the IR mode to <On>, the LED comes on and the screen is automatically set to
`
M
black-and-white mode. When you set the IR mode to <Off>, the LED goes off and day-and-night
mode is automatically set.
If the zoom magnification is changed while the IR dimmer is being used, the IR dimmer is
`
interfaced to the zoom magnification.
However, the interface of IR dimmer to zoom magnification may slow down at a low temperature.
If the ambient temperature is too high, IR LED may be forcefully turned off to protect the product.
`
96_ setup screen