Appliance Setup; Remove Glass Assembly; Remove The Shipping Materials; Clean The Appliance - Heat & Glo SUPREME-N-I30AU Owner's Manual

12 12

Appliance Setup

A. Remove Glass Assembly
See Section 12.H.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included with
accessories. Contact your dealer for a list of approved ac-
cessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional accesso-
ries with this appliance. Using non-listed accessories could
result in a safety hazard and will void the warranty.
E. Place the Lava Rock
WARNING! Risk of Explosion! Follow lava rock placement
instructions in manual. DO NOT place lava rock on burner.
Improperly placed lava rock interferes with proper burner op-
eration.
Lava rock is shipped with this gas appliance. To place the
lava rock:
• Lava rock CANNOT be placed on the burner.
• Place lava rock in front of and to the sides of the burner.
PLACE LAVA ROCK IN SHADED AREA ONLY
Figure 12.1 Placement of Lava Rock
Heat & Glo • Supreme-N-I30AU, Supreme-P-I30AU • 2222-900 Rev. X • 6/14
F. Ember Placement
WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT place embers directly over
burner ports. Replace ember material annually. Improperly
placed embers interfere with proper burner operation.
Ember material is shipped with this gas appliance. To place
the ember material:
• Embers CANNOT be placed directly over ports. Care
should be taken not to cover the lighting trail of ports (from
back to front).
• Place 3/8 in. (10 mm) size pieces of Glowing Embers®
just in front of the port trail, but not on or in between the
ports (see Figure 12.2). Care should be taken so that the
ports are not covered. Failure to follow this procedure will
likely cause lighting and sooting problems.
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
EMBERS NOT
ALLOWED ON
ANY PORTS
EMBERS NOT
ALLOWED IN
PILOT AREA
Figure 12.2 Placement of Embers
47