14
Appliance Setup
A. Remove Fixed Glass Assembly
See Section 9.D.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
DO NOT MODIFY THIS APPLIANCE
Heat & Glo • 350TSI-P-CEM • 2033-973 Rev. G • 4/17
E. Air Shutter Setting
Air shutter settings should be adjusted by a qualified ser-
vice technician at the time of installation. The air shutter
is set at the factory for minimum vertical vent run. Adjust
air shutter for longer vertical runs. See Figure 14.1.
•
Loosen the wing nut.
•
Move the air handle to the left to open the air shutter.
•
Move the air handle to the right to close the air
shutter.
•
Tighten the wing nut.
NOTICE: If sooting occur, provide more air by opening
the air shutter.
Figure 14.1 Air Shutter
350TSI-P-CEM
AIR SHUTTER
WING NUT
Natural Gas
Propane
0,6 cm
FULL OPEN
59