Installer Guide; Getting Started; Typical Appliance System - Heat & Glo SUPREME-N-I30AU Owner's Manual

4 4

Getting Started

A. Typical Appliance System
NOTICE: Illustrations and photos refl ect typical installations and are for design purposes only. Illustrations/diagrams are not
drawn to scale. Actual product may vary from pictures in manual
NON-COMBUSTIBLE ROOF FLASHING
MAINTAINS MINIMUM CLEARANCE
AROUND PIPE (SECTION 6 & 8)
(SECTION 6 & 8)
CEILING FIRESTOP
ON FLOOR OF ATTIC
(SECTION 8)
3 in. (76 mm)
FLEX LINERS
(SECTION 8)
FRAMING/HEADER
(SECTION 5)
GAS LINE (SECTION 9)
ACCESS THROUGH EXISTING
MASONRY OR WOODBURNING
FIREPLACE
Figure 4.1 Typical System
16

Installer Guide

VERTICAL TERMINATION CAP
VENT PIPE
Heat & Glo • Supreme-N-I30AU, Supreme-P-I30AU • 2222-900 Rev. X • 6/14
STORM COLLAR
(SECTION 6 & 8)
VENT PIPE PENETRATES
ROOF PREFERABLY
WITHOUT AFFECTING
ROOF RAFTERS
(SECTION 8)
DOUBLE LINED FLUE
TO COMPLY WITH AS2918:2001 AND THE
BUILDING CODE OF AUSTRALIA
REQUIRED ISOLATION SWITCH: AS5601
LOCATION WITHIN 1 METER OF FIREPLACE,
SUBJECT TO MANTEL PIECE, ETC. CHECK
TO ENSURE IT REMAINS CLEAR ON ANY
MANTEL PIECE INSTALLATION
OPTIONAL WALL SWITCH
MANTEL AND MANTEL LEG
SECTION 5.B AND 11.A
SURROUND OR FRONT
SECTION 2.D AND 12.J.
HEARTH EXTENSION
NOT SHOWN