Fan Installation - Heat & Glo SUPREME-N-I30AU Owner's Manual

Figure 10.6. Mounting Remote Control Housing
AUX300CE Module Installation
• Insert the 4 hole harness from the AUX300CE module into
the 4 pin plug on the control module. See Figure 10.7.
CONTROL MODULE CONTROL MODULE
Figure 10.7 AUX 300 Module Installation

Fan Installation

• Insert the 3 prong plug from the fan into the receptacle
located in the AUX300CE module. See Figure 10.8.
• Insert 3 prong plug from AUX300CE module into REM/
AUX receptacle of fi replace junction box.
AUX 1: AUX 2: 3 PRONG PLUG (FAN):
3 steps, HIGH, ON/OFF
MED and LOW 7 min. ON, 12 min. OFF
AUX 300 AUX 300
MODULE MODULE
Figure 10.8 Plug Fan into AUX300CE Module
AUX 300CE AUX 300CE
CABLE CABLE
3 steps, timer based,
FAN CORD FAN CORD
Heat & Glo • Supreme-N-I30AU, Supreme-P-I30AU • 2222-900 Rev. X • 6/14
Programming the RC300AU to the Control Module
CAUTION! Risk of burns! DO NOT program the remote
control to the control module when fi replace is hot.
• Verify the ON/OFF/REMOTE switch is in the REMOTE
position. Green LED light will blink three times and wall
switch will beep once 5 seconds later when ready. See
Figure 10.9.
• Using a small item (such as a paper clip) press and
release the LEARN button located near the ON/OFF/
REMOTE switch. See Figure 10.9.
• Control module will beep once and LED will blink green
for 10 seconds.
• While the LED is blinking, press the POWER button on
the remote control. A double beep will come out of the
control module to indicate that it has been programmed
successfully.
NOTICE: Up to three remote controls can be programmed
into the control module. Simply press a button on the other
remote controls during the 10 second programming process
to add another remote into the system. It is recommended
to program only one RC300AU remote control.
To clear memory in the control module, use a small item
(such as a paper clip) to press and release the LEARN
button. Control module will beep once and LED will blink
green for 10 seconds DO NOT press any buttons on the
remote during the ten seconds that the green LED blinks.
The memory will be cleared. Note that the RC300AU will
not be programmed if it's in STANDBY mode. Press the
ON/OFF button twice to switch to IDLE mode.
REMOTE POSITION
Figure 10.9. Programming RC300AU
LEARN BUTTON
41