User Definitions (Level 2 Menu) - JRC JSS-296 Service Manual

(k) Then gradually turn RV2 on the PA CONTROL UNIT clockwise until PA BIAS reading becomes
2.0A.
(l) When PA CONTROL UNIT is CMC-2695 or CMC-2698, adjust RV101 and RV102 continuously.
RV101:
RV102:
(m)When PA CONTROL UNIT is CMC-2698, adjust RV201 and RV202 continuously.
RV201:
RV202:
(n) PA BIAS-level adjustment is finished.
(o) Turn off the "AC" switch and re-assemble the unit.
4.2.6

User Definitions (Level 2 MENU)

Do not select "POWER DATA CLR" and "PA POWER SET" of menu item .
Doing so may cause malfunction.
Turn on the "AC" and "DC" switch, pressing MENU to access the following the level 2 menu.
Item
PA IN, PA OUT
ARRESTOR VOLT
CHARGE FUNCTION
BATT USE SET
USR SETTING CLR
POWER DATA CLR
80V ADJUST
PA BIAS ADJUST
CHG VOLT ADJUST
PA POWER SET
TERMINAL
50
PA BIAS ADJUST
2.0 A
2.0A 3.0A
3.0A 4.0A
4.0A 5.0A
5.0A 6.0A
CAUTION
Function
Display the RF input and RF output power.
Display the PA arrester voltage.
Set the battery charger ON or OFF.
Set the battery operation equipment.
Initialize the user setting parameter.
Initialize the TX power setting data.
Check and adjust PA 80V.
Check and adjust PA BIAS current.
Check and adjust battery charger output
voltage.
Initialize the TX power setting data and
start TX power setting.
Select the terminal unit to the NDZ-127J or
NCH-1961/1962.
Parameter Default
Setting
ON/OFF
DUAL/SINGLE SINGLE(SES,HF)
ORDINARY ORDINARY:26.2V
EQUAL EQUAL:
NDZ/NCH
ON
29.4V
NDZ