Notes On Using The Printer - JRC JSS-296 Service Manual

Notes on using the printer

Be sure to turn OFF the printer's power when opening and closing the printer cover.
Failure to comply could result in electrical shock, failure, or injury.
Do not drop or strike the printer.
Doing so may cause failure or malfunction.
Just after printing, the temperature of the printing head is high.
Do not touch the printing head until the temperature goes down.
Doing so may cause a burn or an injury.
Never try to disassemble or repair the printer yourself.
Doing so may cause failure or malfunction.
Do not touch any part of the cutter.
Doing so is potentially dangerous.
When attaching the ribbon, be sure it does not get twisted.
Doing so may cause failure or malfunction.
Wait at least two seconds to restart the system after turning the power switch OFF.
Otherwise the initialization may not proceed correctly or a malfunction may occur.
Do not attempt to print without the ribbon cassette cartridge or paper.
Doing so may cause failure or malfunction.
When the printer is working, be sure not to allow your hands, any articles of clothing
or accessories (a necktie or jewelry for instance) too close to the unit.
Doing so may cause injury.
Do not place anything such as liquids or metals on top of the printer.
They may drop into the printer, causing fire or malfunction.
Do not install the printer in the following locations.
Doing so may cause a fire, malfunction or degradation of printing quality.
･ On a surface that is not horizontal, or where the vibration is severe.
･ In a location subject to direct sunlight or excessive dust.
･ In a location subject to extremely high or low temperatures.
･ In a location subject to excessive humidity.
CAUTION
33