Setting The Squelch Level - JRC JSS-2250 Instruction Manual

4.3.7

Setting the squelch level

■ ■
Procedure
1 1 . .
1 .
Press the
MENU
hierarchical menus, after 5.4 Receiver
appears, move the cursor to 5. Squelch.
2 2 . .
2 .
Press ENT to move the cursor to the right,
then use the jog dial or numeric keypad to
input a value in the range of 000 to 100.
After inputting and pressing ENT, the settings
are complete.
- Setting the value to 000 automatically
Note
displays it as OFF.
- This function is invalid in the DSC
mode or the telex mode.
4.3.8 Setting the CW bandwidth
■ ■
Procedure
1 1 . .
1 .
Press the
MENU
hierarchical menus, after 5.4 Receiver
appears, move the cursor to 6. CW
bandwidth.
2 2 . .
2 .
Press ENT to move the cursor to the right,
then use the jog dial to select Wide or
Narrow.
After inputting and pressing ENT, the settings
are complete.
Setting the value to 000 automatically
-
Note
displays it as OFF.
- This function is enabled in CW mode
only.
key, and through
key, and through
5.4)Receiver
1.Auto gain control :Slow
2.Noise reduction :OFF
3.Attenuation :OFF
4.Clarifier :+000Hz
5.Squelch :OFF
6.CW bandwidth :Narrow
7.Scan
0.Back
5.4)Receiver
1.Auto gain control :Slow
2.Noise reduction :OFF
3.Attenuation :OFF
4.Clarifier :+000Hz
5.Squelch :012
6.CW bandwidth :Narrow
7.Scan
0.Back
5.4)Receiver
1.Auto gain control :Slow
2.Noise reduction :OFF
3.Attenuation :OFF
4.Clarifier :+000Hz
5.Squelch :OFF
6.CW bandwidth :Narrow
7.Scan
0.Back
5.4)Receiver
1.Auto gain control :Slow
2.Noise reduction :OFF
3.Attenuation :OFF
4.Clarifier :+000Hz
5.Squelch :OFF
6.CW bandwidth :Narrow
7.Scan
0.Back
Operation
4-31