Elevated Hearth Systems - Heat & Glo ESC-42ST Owner's Manual

Heat & glo esc-42st gas fireplace

Table of Contents

D. Elevated Hearth Systems

Use the table below to identify the hearth system that will be used. The table will also help identify effects on the various

dimensions. Some hearth systems will elevate the appliance off the ﬂ oor at a given dimension. The dimension noted in the

table below, in the Elevated Appliance Dimension Column, will also have to be added to the following: Extension Wall Hole

referenced in Figure 8.2 (Exterior Wall Hole) and Rough Opening Height (header height) referenced in Figure 5.2. Note:

Finished ﬂ oor thickness should also be considered when determining installation dimensions.

MODEL

ESC-42ST

Note 1. Add dimensions to Exterior Wall Hole (Figure 8.2) and Rough Opening Height (Figure 5.2).

The above listed Hearth and Home Technologies manufactured hearth systems have been tested and certiﬁ ed for use with

the ESC-42ST ﬁ replace. The dimensions of these Hearth and Home Technologies manufactured hearth systems may

differ slightly from the mantel speciﬁ cations listed in Section 5.D and Section 13.A. The above listed Hearth and Home

Technologies manufactured hearth systems are not required to meet the mantel speciﬁ cations listed in Section 5.D and

Section 13.A.

DESCRIPTION

Avalon Cast Mantel

Biltmore Cast Mantel

Hearst Cast Mantel

Heat & Glo • ESC-42ST • 2146-900 Rev. V • 5/14

ELEVATED APPLIANCE DIMENSION

PART #

AFANTC5244

AFBETC5244

AFHTTC5244

See Note 1

1/2 in.

Table of Contents