Elevated Hearth Systems - Heat & Glo ST-36TRB-IPI Owner's Manual

E. Elevated Hearth Systems
Use the table below to identify the hearth system that will be used. The table will also help identify effects on the various
dimensions. Some hearth systems will elevate the appliance off the fl oor at a given dimension. For example, if appliance
will be used with a Kenwood Cabinet with Base, the appliance will be elevated 9-1/4 inches. The 9-1/4 inch elevation
will also have to be added to the following: Extension Wall Hole referenced in Figure 8.2 (Exterior Wall Hole) and Rough
Opening Height (header height) referenced in Figure 5.2. Note: Finished fl oor thickness should also be considered when
determining installation dimensions.
MODEL
KENWOOD MANTEL
KENWOOD MANTEL W/ BASE
LAURENT SURROUND
CAMDEN SURROUND
CAMDEN SURROUND W/HEARTH
CAMDEN SURROUND W/MANTEL
CAMDEN SURROUND W/MANTEL &
HEARTH
ESSEX SURROUND
ESSEX SURROUND W/HEARTH
ESSEX SURROUND W/MANTEL
ESSEX SURROUND W/MANTEL &
HEARTH
MONROE SURROUND
MONROE SURROUND W/HEARTH
MONROE SURROUND W/MANTEL
MONROE SURROUND W/MANTEL &
HEARTH
Note 1. Add dimensions to Exterior Wall Hole (Figure 8.2) and Rough Opening Height (Figure 5.2).
Note 2. Verify Marble Cut Lengths on site prior to cutting.
Note 3. Dimensions assume use of a 3/4 in. Hearth Pad.
60 Heat & Glo • ST-36TRB-IPI, PIER-36TRB-IPI, LCOR-36TRB-IPI, RCOR-36TRB-IPI • 2128-900 Rev. R • 12/15
DESCRIPTION PART #
AFKDMPB
AFKDMPB W/ HTKDMPB
LAURENT-36
CAM36PG
CAM36PGH
CAMM36PG
CAMM36PGH
ESSEX36PG
ESSEX36PGH
ESSEXM36PG
ESSEXM36PGH
MON36PG
MON36PGH
MONM36PG
MONM36PGH
ELEVATED APPLIANCE MARBLE LEG CUT
DIMENSION
See Note 1
0 (See Note 3)
9-1/4 in.
1-1/2 in.
0
1-3/4 in.
0
1-3/4 in.
0
1-3/4 in.
0
1-3/4 in.
0
1-3/4 in.
0
1-3/4 in.
LENGTH
See Note 2
27-3/8 in.
29-3/8 in.
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A