Edit Route (Set Route Sequence) - JRC JMA-9133-SA Instruction Manual

>
JMA-9100 Instruction Manual 3.BASIC OPERATION
3.7.1.1 Displaying route created by the radar system (Internal)
In this radar system, route created by the radar system are displayed as shown below.
Planned Course
070T
2.50kn
000
ABCDE
Planned Speed
Route alarm line
The following rout data is displayed.
Waypoint : Up to 512 points (number: 000 to 511), comments can be entered.
To Waypoint : Next Waypoint is displayed in a light blue circle.
Planned Courese : Scheduled route between Waypoints (automatically calculated).
Planned Speed : Scheduled sailing speed between Waypoints (entered by user).
Waypoint alarm circle : The circle that shows the distance to judge arrival in Waypoint.
Route alarm line : The line that shows the distance width to judge route alarm.
Waypoint bearing vector : A vector line that shows next destination from own ship's CCRP.
3.7.2

Edit Route (Set Route Sequence)

In this radar system, it is possible to easily create and correct route by performing
operation on the radar display.
3.7.2.1 Initializing route data (New Monitor Route)
Route data saved in the radar system is initialized.
>
3.7 USE ROUTE FUNCTION
001
Route alarm line
Waypoint bearing vector
135T
5.00kn
To Waypoint
Route : A route line that connects Waypoints.
Once route data is initialized, route data saved in the
NOTE:
radar system's storage section is deleted. If there is
necessary route data, save the route data on the flash
memory card before initializing it.
3－ 68
Waypoint
062T
10.0kn
Route
002 FGJK
Waypoint alarm circle
074T 004
12.5kn
003 OPQRS
Comments
Waypoint number