Ais Operation; Restrictions; Setting Ais Display Function (Ais Function) - JRC JMA-9133-SA Instruction Manual

JMA-9100 Instruction Manual
5.3

AIS OPERATION

5.3.1

Restrictions

The following restrictions are placed on use of the AIS function.
The AIS function is unavailable in the following cases:
• or
MAN
• The current offset (Set/Drift Setting) is set while
for the speed sensor.
• The GPS geodetic system is used except WGS-84.
or
LOG 2AXW
• The AIS function is turned on and the current offset (Set/Drift Setting) is
selected.
cannot be selected for the speed sensor in the following case:
MAN
• The AIS function is On.
Current offset (Set/Drift Setting) cannot be turned On in the following case:
• or
LOG
5.3.2

Setting AIS Display Function (AIS Function)

• When the AIS function is set to Off, the AIS display
• Once the AIS display function is set to Off, it is not
Procedures
1) Press the [AIS/TT] key. Alternatively, left-click the
in the Target Information located at the upper right of the display.
The received AIS information will be shown on the radar display.
>
5.OPERATION OF TARGET TRACKING AND AIS
is selected for the speed sensor.
REF.
cannot be selected for the speed sensor in the following case:
is selected for the speed sensor while the AIS function is on.
2AXW
Attention
function is turned off and AIS symbols are no longer
displayed.
automatically switched to On even if a dangerous
target exists.
5－ 27
>
5.3 AIS OPERATION
or is selected
LOG 2AXW
button
AIS
5