Use Video Processing (Proc) - JRC JMA-9133-SA Instruction Manual

>
JMA-9100 Instruction Manual 3.BASIC OPERATION
3.4.4

Use Video Processing (PROC)

This function reduces unnecessary noise to highlight targets.
Procedures
1) Left-click the PROC button located at the lower left of the
display.
The video processing modes are switched.
PROC Off
Video process modes
PROC Off
3Scan CORREL
4Scan CORREL
5Scan CORREL
Remain
Peak Hold
>
3.4 GENERAL RADAR OPERATION
Attention
• When viewing a radar beacon, SART signal, or fast
moving target on the radar display, select
PROC Off (video process off).
• If video processing mode is set to CORREL , it may
be difficult to detect high speed target.
→
3Scan CORREL
←
Peak Hold
: Select this mode in general.
: Select this mode when many rain/snow clutter returns are detected.
: Select this mode to highlight targets while suppressing sea clutter
returns.
: Select this mode to detect small targets hidden by sea clutter
returns.
: Select this mode when own ship yaws wildly.
: Select this mode to detect small targets of which detection
probability is low.
3－ 26
→
4Scan CORREL
←
Remain 5Scan CORREL