Hot Line Dial String For Selected Line; Hot/Warm Phone; Initial Digit Timer - Siemens optiPoint 410 entry Administrator's Manual

Alphabetical Reference

Hot line dial string for selected line

This is the hotline target for this line. Can only be set by administrator in
web interface.
! page 128

Hot/Warm Phone

This dropdown allows the user to specify the Hot Line/Warm Line opera-
tion of the phone. There are three options:
•
•
•
1. If the phone is part of a keysystem group, there may be a Hot Line dial
2. If the phone is not part of a keysystem group.
! page 63

Initial Digit Timer

This timer determines the delay after which the phone goes back to idle
mode or calls a specified number (if "Warm line" is active) when the hand-
set was lifted or the speaker key was pressed and no number was dialled.
! page 63
190
Normal line Action: Any Hot Line/Warm Line parameters associated
with the phone will be ignored, regardless of whether or not the phone
is in a keysystem group.
Warm line: If there is a default dial string set against the phone then it
will be automatically dialled (after the delay set with "Initial Digit Tim-
er") when the user lifts the handset. This occurs regardless of whether
or not the phone is in a keysystem group.
Hot line: There are two cases to consider, depending on whether the
phone is part of a keysystem group.
string associated with each of the Line keys on the phone
– If there is a Hot Line dial string associated with the line then, it will
be automatically dialled immediately when the line is manually se-
lected.
– If there is not a Hot Line dial string associated with the Line, but
there is a Default dial string set against the phone, then the Default
dial string will be automatically dialled immediately when the line is
manually selected.
– If there is not a Hot Line dial string associated with the Line, and
there is not a Default dial string set against the phone, then the user
will receive dial tone when the line is manually selected.
– If there is a Default dial string set against the phone, then it will be
automatically dialled immediately when the line is manually selected.
– If there is not a Default dial string set against the phone, then the
user will receive dial tone when the line is manually selected.
! page 116
! page 116