• The following window opens. Click "Finish"
The following window opens. Click "Finish"
The installation is complete.
B-Connect one end of the "MUXDIAG II" interface cable to a USB port on your computer;
Connect one end of the "MUXDIAG II" interface cable to a USB port on your computer;
Connect one end of the "MUXDIAG II" interface cable to a USB port on your computer;
connect the other end to the diagnostic connector on the motorcycle.
connect the other end to the diagnostic connector on the mo
Check to make sure that the "MUXDIAG II" is receiving power. The LED lights should be lit.
Check to make sure that the "MUXDIAG II" is receiving power.
• Solid blue : The PC connection has been successfully establi
: The PC connection has been successfully established
• Flashing blue : Connected to
• Blue LED off : The PC is off or in standby mode
connection
• Steady green : There is a problem with the software
• Flashing green (slow): The software is functioning correctly
• Flashing green (fast) : Connected to
• Green off : The firmware is not present
: The firmware is not present
• Solid red : The card is receiving power
: The card is receiving power
All LED's off: The unit is not plugged in, it is in standby
All LED's off: The unit is not plugged in, it is in standby mode or there is a USB problem
Connected to current PC
: The PC is off or in standby mode or there is a problem with the USB
: There is a problem with the software
The software is functioning correctly
Connected to current PC
The LED lights should be lit.
or there is a problem with the USB
or there is a USB problem
49/75