SHERCO 2014 250 SEF-R Workshop Manual page 30

Reassembling the ignition case: Reassembling the ignition case:
•
Install the free wheel gear. Install the free wheel gear.
•
Reinstall the two starter shafts and their Reinstall the two starter shafts and their
gears.
•
Visually inspect the oil seal on the oil Visually inspect the oil seal on the oil
centrifuge.
•
Use special tool number 1818 to install Use special tool number 1818 to install
the oil centrifuge.
Tighten the oil centrifuge fixing screw to the Tighten the oil centrifuge fixing screw to the
appropriate torque.
This screw thread is reversed, it is a LH This screw thread is reversed, it is a LH
thread.
•
Screw and tighten the centrifuge. Screw and tighten the centrifuge.
Torque the centrifuge fixing screw to: 8 Nm. Torque the centrifuge fixing screw to: 8 Nm.
•
Inspect Inspect the the
necessary.
•
Pre assembly the rotor group Pre assembly the rotor group
•
Assembly the free wheel in its housing. Assembly the free wheel in its housing.
Tighten this set to the rotor with the 8 M5 Tighten this set to the rotor with the 8 M5
screws (apply thread locker blue on the screws (apply thread locker blue on the
screws).
Torque the M5 screw to: 8 Nm. screw to: 8 Nm.
•
Install the rotor (turn the rotor counter Install the rotor (turn the rotor counter
clockwise to help facilitate the installation of the acilitate the installation of the
lighting rotor).
•
Apply proper tightening torque to the nut Apply proper tightening torque to the nut
on the rotor with strong thread locker
•
Install the conical washer Install the conical washer.
•
Using special tool number 4753 to hold Using special tool number 4753 to hold
the rotor tighten the fixing nut.
Torque the fixing clutch nut to 80 Nm with
thread locker (blue).
ATTENTION ! check the clearance
between the rotor and the oil centrifuge between the rotor and the oil centrifuge
•
Install the remaining shafts and gears. Install the remaining shafts and gears
•
Install the two case locating pins. Install the two case locating pins
•
Install a new gasket.
•
Install the ignition crankcase cover and Install the ignition crankcase cover an
tighten the 10 screws.
Torque the ignition crankcase cover screws Torque the ignition crankcase cover screws
to: 10 Nm.
rotor rotor key, key, change change
thread locker.
ch nut to 80 Nm with
check the clearance
if if
30/75