Removing The Motor - SHERCO 2014 250 SEF-R Workshop Manual

Removing the motor

Removing the motor
Removing the motor:
To remove the engine, you must remove To remove the engine, you must remove
the swing arm axle, the swing arm and the rear the swing arm axle, the swing arm and the rear
wheel. To keep the bike from falling, remember wheel. To keep the bike from falling, remember
to support the chassis with an appropriate jack. to support the chassis with an appropriate jack.
•
Drain (refer to the owners manual) Drain (refer to the owners manual)
the engine oil
-
the engine coolant
-
•
Remove the seat.
•
Disconnect the battery.
•
Remove the fuel tank and its covers. Remove the fuel tank and its covers.
•
Disconnect Disconnect
connectors from the engine. (Starter, TPS connectors from the engine. (Starter, TPS
sensor, water temperature sensor, coil, fuel sensor, water temperature sensor, coil, fuel
injector).
•
Remove the exhaust.
•
Remove the ignition coil.
•
Remove the fuel injector body. Remove the fuel injector body.
•
Remove the chain.
•
Remove the chain guard. Remove the chain guard.
•
Remove the clutch actuating cylinder. Remove the clutch actuating cylinder.
When the clutch actuating cylinder is When the clutch actuating cylinder is
removed the piston is loose. Hold the piston it removed the piston is loose. Hold the piston it
in place using a plastic strap.
•
Remove Remove all all
connected to the motor.
•
Remove the left radiator. Remove the left radiator.
•
Loosen all of the engine bolts [A]. Loosen all of the engine bolts
•
Loosen the swing arm bolt. Loosen the swing arm bolt.
•
Remove the brackets that attach the Remove the brackets that attach the
cylinder head to the chassis.
•
Remove the motor mounting bolts. Remove the motor mounting bolts.
•
Remove the swing arm bolt. Remove the swing arm bolt.
•
Remove the motor.
ant
all all the the electrical electrical
coil.
of of the the water
wiring wiring
hoses
10/75