Table of Contents
Advertisement
Reassembling the top end of the motor:
Reassembling the top end of the motor:
Reassemble the piston
•
Install the piston rings on the piston with
Install the piston rings on the piston with
the end gaps as shown in the photo, the
end gaps as shown in the photo, the
compression ring goes in the top groove and
compression ring goes in the top groove and
the oil control ring goes in the bottom groove.
the oil control ring goes in the bottom groove.
A Lower expander end gap
B Lower piston ring end gap
C Upper expander end gap
D Upper piston ring gap
The expander rings do n
bottom; however the oil control ring and the
bottom; however the oil control ring and the
compression ring must be installed with the
compression ring must be installed with the
« N » mark facing up.
•
Apply engine oil to the wrist pin internal
Apply engine oil to the wrist pin internal
bore in the piston.
•
Carefully note the piston orientation (the
note the piston orientation (the
small cut outs are on the exhaust side)
•
Install the locating pins [B].
•
Install the base gasket [C].
Install the base gasket [C].
•
Use
Use
special
special
maintain the piston in the correct location [A].
maintain the piston in the correct location [A].
•
Place one of the cir clips in the special
Place one of the cir clips in the special
tool number 2075 as shown in the photo; install
tool number 2075 as shown in the photo; install
the clip close to one end of the tool.
clip close to one end of the tool.
•
Use the tool to set up the clip for
Use the tool to set up the clip for
installation on the wrist pin.
•
Install the cir clip on the wrist pin.
Install the cir clip on the wrist pin.
ot have a top or
the exhaust side)
ing pins [B].
tool
tool
number
number
1821
1821
C
to
to
B D
B D
C
A
B
18/75
A
Hide quick links:
Advertisement
Table of Contents
