SHERCO 2014 250 SEF-R Workshop Manual page 28

Disassembling the left side Disassembling the left side
For additional details refer to the parts catalog 250 SEF-R and 300 SEF-R For additional details refer to the parts catalog
Disassembling the ignition case: Disassembling the ignition case:
•
Drain the engine oil.
•
Remove the 10 screws that retain the Remove the 10 screws that
ignition case.
•
Visually inspect the inner surfaces of the Visually inspect the inner surfaces of the
rotor [A] and the outer surfaces of the stator [B]. rotor [A] and the outer surfaces of the stator [B].
•
Check the pulse generator (sensor) Check the pulse generator (sensor)
•
Replace if necessary.
Replacing the stator and sensor system: Replacing the stator and sensor system:
•
Remove the two screws that retain the Remove the two screws that retain the
sensor [C] and the two screws that retain the sensor [C] and the two screws that retain the
stator [D].
•
Install the new parts.
•
Reinstall the screws using the proper Reinstall the screws using the proper
torque with strong Loctite (red)
Do not forget the AET washers below the stator Do not forget the AET washers below the stator
screws.
Torque the stator and sensor screws to: Torque the stator and sensor screws to:
8Nm.
R.
A
B
28/75
C
D