SHERCO 2014 250 SEF-R Workshop Manual page 26

Removing the clutch hub and the clutch basket: Removing the clutch hub and the clutch basket:
•
Drain the engine oil and the engine Drain the engine oil and the engine
coolant.
•
Remove the
disassembling the right side paragraph) disassembling the right side paragraph)
•
Remove the clutch. (see clutch removal Remove the clutch. (see clutch removal
paragraph)
•
Remove the clutch release bearing Remove the clutch release bearing
assembly.
•
Retain the clutch hub using tool 1814. Retain the clutch hub using tool 1814.
•
Loosen the clutch hub nut. Loosen the clutch hub nut.
Attention, make sure the special timing Attention, make sure the special timin
tool number 1819 is not installed, if it is, severe tool number 1819 is not installed, if it is, severe
damage could occur to the crankshaft and damage could occur to the crankshaft and
crankcase.
•
Remove the hub and the nut. Remove the hub and the nut.
•
Inspect the needle bearings and replace Inspect the needle bearings and replace
if necessary.
•
Visually inspect the hub and the housing. Visually inspect the hub and the housing.
Reassembling the clutch hub components:
•
Install the thrust washer. Install the thrust washer.
•
Install the needle bearings. Install the needle bearings.
•
Install the clutch housing. Install the clutch housing.
ATTENTION ! the clutch basket wheel is
appeared with the primary gear. appeared with the primary gear.
•
Install the spacer washer. Install the spacer washer.
•
Install the clutch hub.
•
Install the special washer Install the special washer.
•
Apply thread locker (blue) to the nut Apply thread locker (blue) to the nut
thread
•
Install the fixing nut
Torque the fixing nut to: 80Nm. Torque the fixing nut to: 80Nm.
•
Check for free rotation of the clutch hub. Check for free rotation of the clutch hub.
•
Blend the special washer over the nut. Blend the special washer over the nut.
•
Install the seat, judder spring seat, judder spring
clutch ch housing. housing.
hub components:
the clutch basket wheel is
(see (see
26/75