Motor Top End - SHERCO 2014 250 SEF-R Workshop Manual

Motor top end

For additional details refer to the parts catalog 250 SEF-R _ 300 SEF-R For additional details refer to the parts catalog
Removing the cylinder head:
•
Remove the spark plug.
•
Remove the valve cover.
•
Remove the three valve cover screws. Remove the three valve cover screws.
These three screws are equipped with
rings ref: 0900.
•
Remove the cap from the ignition cover. Remove the cap from the
[A].
•
Remove the timing control plug Remove the timing control plug [A]
•
Turn the engine counterclockwise in Turn the engine counterclockwise in
order to align the timing marks on the order to align the timing marks on the
crankshaft with the marks on the timing gear. crankshaft with the marks on the timing gear.
Install the special tool that locks the engine at ecial tool that locks the engine at
Top Dead Center [A] (ref 1819) Top Dead Center [A] (ref 1819)
.
s are equipped with o-
A
A
A
12/75