Log Replacement; Door Gasket; Latch Adjustment; Glass Replacement - Regency ULTIMATE U39 Owners & Installation Manual

maintenance
|
38

LOG REPLACEMENT

The unit should never be used with broken logs.
Turn off the gas valve and allow the unit to cool
before opening door to carefully remove the
logs. The pilot light generates enough heat to
burn someone. If for any reason a log should
need replacement, you must use the proper
replacement log. The position of these logs
must be as shown in the diagram under Log
Installation.
Note: Improper positioning of logs may
create carbon build-up and will alter
the unit's performance which is not
covered under warranty.

DOOR GASKET

If the door gasket requires replacement use 7/8"
diameter oval door gasket (Part # 846-570).

LATCH ADJUSTMENT

The door latch may require adjustment as the
door gasket material compresses after a few
fires and after glass replacement. Turn the
adjustable catch to tighten or loosen the latch.
GLASS
REPLACEMENT
Your ULTIMATE stove is supplied with high
temperature, 5 mm Neoceram ceramic glass
that will withstand the highest heat that your unit
will produce. In the event that you break your
glass by impact, purchase your replacement
door from an authorized Regency
and follow our step-by-step instructions for
replacement. The glass is not sold separately,
as it must be properly sealed in the door frame.
Replacement Part #
940-325/P U39 Wraparound Glass
WARNING: Do not operate appliance
with glass panels removed, cracked
or broken. Replacement of the glass
should be done by a licensed or
qualified service person.
Note: Wearing gloves will protect your hands
while handling glass.
38 |
Regency U39-10 ULTIMATE Direct Vent Freestanding Gas Stove
®
Panel Glass Replacement
1. Remove the door from the unit and place on
a soft surface to prevent scratching.
2. Pull out the door gasket.
3. Remove the nuts holding the glass retainers
in place.
4. Remove the glass retainers (sides, top and
bottom) and the door catch plate.
5. Replace the glass. The glass must have
gasketing around it.
6. Reverse the previous steps, replace the
retainers and fasten with the nuts but do
not overtighten, as this can break the glass.
Note: the door catch plate fits on top of the
left side retainer.
7. Put gasket glue on the retainers, but do not
put glue on the screws. Replace the door
gasket, the two ends butt tight together on
the bottom edge of the door.
8. Replace door on the stove and check the
seal.
Panel Glass Door Assembly
dealer only,
®
Wraparound Assembly Door
(same glass retainers as the
Panel Assembly)
Installing Glass
1. Place glass assembly into door frame.
2. Install retainers by placing 1 drop of glue where
previously glued and put in place.
3. Install side retainers.
4. Install door catch plate.
5. Install the 24 nuts loosely, do not tighten.
6. Tighten side panels nuts using the following
procedure:
a. tighten top & bottom outside corner nuts
(2.
b. tighten inside nuts (3.
c. tighten top & bottom inside corners (2.
7. Tighten the 10 nuts on center glass retainer.
8. Repeat step 7 for other side panel.
9. Replace new gasket by gluing it in place.
10. Install door onto stove and check the seal.