Maintenance Instructions; Log Replacement; Door And Glass Gasket; Glass Replacement - Regency ULTIMATE U38E Owners & Installation Manual

Maintenance
Instructions
1) Always shut the valve off before cleaning. For
relighting, refer to lighting instructions. Keep
the burner and control compartment clean by
brushing and vacuuming at least once a year.
When cleaning the logs, use a soft clean brush
as the logs are fragile and easily damaged.
2) Clean glass (never when unit is hot), appliance,
louvers, and door with a damp cloth. Never use
an abrasive cleaner. The gold louvers (and op-
tional gold door) may be scratched if abrasives
are used to clean them.
The heater is finished in a heat resistant paint
and should only be refinished with heat resist-
ant paint (not with wall paint). Regency
StoveBright Paint - Metallic Black #6309.
3) Make a periodic check of burner for proper posi-
tion and condition. Visually check the flame of
the burner periodically, making sure the flames
are steady; not lifting or floating. If there is a
problem, call a qualified service person.
4) The appliance and venting system must be
inspected before use, and at least annually, by
a qualified field service person, to ensure that
the flow of combustion and ventilation air is not
obstructed.
During the annual service call, the burners
should be removed from the burner tray and
cleaned. Replace the embers - do not block
the pilot or burner ports.
5) Keep the area near the appliance clear and
free from combustible materials, gasoline and
other flammable vapours and liquids.
6) Verify proper operation after servicing.

Log Replacement

The unit should never be used with broken logs. Turn
off the gas valve and allow the unit to cool before
opening door to carefully remove the logs. The pilot
light generates enough heat to burn someone. If
for any reason a log should need replacement, you
must use the proper replacement log. The position
of these logs must be as shown in the diagram
under Log Installation.
Note: Improper positioning of logs may create
carbon build-up and will alter the unit's
performance which is not covered
under warranty.
Door and Glass
Gasket
If the door gasket requires replacement use
7/8" diameter oval door gasket (Part # 732-570).
The glass requires 7/8" flat glass gasket. See your
Regency dealer.
®

Glass Replacement

Your Regency stove is supplied with high tem-
®
perature, 5 mm Neoceram ceramic glass that
will withstand the highest heat that your unit will
produce. In the event that you break your glass,
purchase your replacement from an authorized
Regency dealer only, and follow the step-by-step
®
instructions for replacement. Never operate your
unit with broken glass.
uses
®
WARNING: Do not operate appliance with the
glass front removed, cracked or broken. Replace-
ment of the glass should be done by a licensed
or qualified service person.

Panel Door

1) Remove the door from the unit and place on a
soft surface to prevent scratching.
2) Pull out the door gasket.
3) Remove the nuts holding the glass retainers in
place.
4) Remove the glass retainers (sides, top and
bottom) and the door catch plate.
5) Replace the glass. The glass must have gas-
keting around it.
6) Reverse the previous steps, replace the retainers
and fasten with the nuts but do not overtighten,
as this can break the glass. Note: the door catch
plate fits on top of the left side retainer.
7) Put gasket glue on the retainers, but do not put
glue on the screws. Replace the door gasket,
the two ends butt tight together on the bottom
edge of the door.
8) Replace door on the stove and check the seal.
Wraparound Assembly Door

Fan Maintenance

If your fan requires maintenance or replacement,
access to the fan is through the access panel on
the rear wall of the firebox.
Note: The unit MUST NOT be operated
without the fan access panel se-
curely in place and correctly sealed.
IMPORTANT: These fans collect a lot
of dust from within your home. Ensure
you maintain these fan motors on a
regular basis by vacuuming out the
fan squirrel cages, around the motor,
and around the grills on the back of
the stove.
Disconnect power supply
before servicing
WARNING: Electrical Grounding
Instructions This appliance is
equipped with a three pronged
(grounding) plug for your protection
against shock hazard and should
be plugged directly into a properly
grounded three-prong receptacle.
Do not cut or remove the grounding
prong from this plug.
Regency U38E-11 ULTIMATE Freestanding Gas Stove
®
maintenance
IMPORTANT
| 33