Electric Grease Gun --- If Equipped - Hitachi ZAXIS 450LC-3 Operator's Manual

ELECTRIC GREASE GUN --- IF EQUIPPED

ZX650LC , 850LC
-3 -3
d
WARNING: The electric grease gun is not a water-
proof type. Do not expose the grease gun to rain
and water. Refrain from using the grease gun while
raining. Failure to do so may cause unexpected
trouble such as an electricity leak. No specified daily
maintenance is required. Take care not to collide
the gun, the motor section especially, with an other
object, or not to leave the gun dirty. Failure to do so
may result in unexpected injury such as an electric
shock. Be sure to keep the electric grease gun clean
by wiping off after use. If left contaminated, the
grease gum may slip out of your hand, possibly
causing a foot injury.
Part Name
1- Switch
2- Motor Unit
3- Nozzle (CPN-2)
4- Cap
5- Grease Cartridge
6- Checking Port
7- Oil Cylinder
8- Chain
Preparation
Install Cartridge Grease
IMPORTANT: Take care not to allow soil and/or dust to
become mixed into grease when installing
grease cartridge (5).
1. Rotate to remove oil cylinder (7) from motor unit (2).
2. Pull chain (8) all the way out of oil cylinder (7) and hang
chain (8) on the notch on the bottom groove of oil
cylinder (7).
3. Remove cap (4) from grease cartridge (5). Install grease
cartridge (5) into the screw hole on motor unit (2).
IMPORTANT: If grease cartridge (5) is diagonally or
forcibly tightened, damage to the screw
threads may result so that grease cartridge
(5) may not be properly installed to motor
unit (2).
4. Install oil cylinder (7) in the original position on motor
unit (2). Unhinge chain (8) from the notch.
MAINTENANCE
3
7-31
4
5
6
7
8
6
8
4
1
2
M16J-07-044
7
M16J-07-042
5
M16J-07-043