The Pen Tray; Mini Rj11 Connector In Insertion Position; Pen Tray And Mounting Brackets; Pen Tray Brackets - Smart Technologies Smart Board Installation Instructions Manual

4. Align the holes in the brackets with the holes in the underside of

the Pen Tray.

5. Insert the four screws you removed in step 2 into the holes in the
flat side of the brackets (two screws on each side). Tighten the
screws with the Robertson screwdriver just enough to hold the
Pen Tray securely. Do not overtighten these screws; the brackets
should be securely, but not rigidly, fixed.
flat side of bracket
Step 2: Connect the MOD4 cable to the whiteboard
1. Place the whiteboard on its side, with the mini RJ11 socket on
the underside of the whiteboard bezel (frame) facing toward you.
2. Grasp the mini RJ11 connector at one end of the MOD4 cable so
that the locking tab faces down and the contacts face up.
angular side of bracket
bracket-to-Pen Tray
machine hole screws

Pen Tray and Mounting Brackets

Mini RJ11 Connector in Insertion Position

SMART Board Installation Guide
Warning
Do not overtighten the
Robertson screws
when attaching the
Pen Tray brackets to
the Pen Tray. The
brackets must be
sufficiently moveable
for a later attachment
step.
underside of Pen Tray
5