Smart Technologies Smart Board Installation Instructions Manual page 32

28
4. Click the Next button.
A large gray rectangular image will almost entirely fill the SMART
Board screen. This screen will contain the number of crosses
associated with the orientation level chosen.
5. Follow the on-screen instructions, pressing your finger
squarely on the yellow center of each red cross, in the order
specified by the large white arrow. To begin the orientation,
press on the cross highlighted in red at the upper-left corner of
the screen. You will hear a beep and the next cross in the series
will be highlighted in red.
NOTE: If you press on the crosses out of sequence or
inaccurately, a Bad Orientation Point dialog will appear. To
correct the bad orientation, select the OK button at the bottom of
the screen using the mouse attached to your computer. This is
necessary because the system has lost Board-awareness while
orienting.
When you have pressed on the final cross, the Orientation
screen will disappear.
6. Test if the orientation was successful by moving your finger
across the Board. The cursor should track your finger very
closely and appear directly underneath the center of your
fingertip.
SMART Board Installation Guide