Attaching The Pen Tray To The Whiteboard; Mod4 Cable With Mini Rj11 4-Wire Connector; Recommended Tools - Smart Technologies Smart Board Installation Instructions Manual

Robertson Screwdriver
MOD4 cable with mini
RJ11 4-wire connector
4

Recommended Tools

While the following tools are not shipped with the SMART Board, we
recommend that you have them on hand to help you in the assembly and
mounting process.
•
bubble level
•
measuring tape
•
masking tape
•
a pencil

Attaching the Pen Tray to the Whiteboard

Hardware Required
•
two Pen Tray mounting brackets
•
Pen Tray
•
Robertson screwdriver (supplied)
•
MOD4 cable (the shorter, black cable with mini RJ11 4-wire
connectors at either end)
Activity Overview
To attach the Pen Tray to the whiteboard, you will:
1. Attach the Pen Tray brackets to the Pen Tray
2. Connect the MOD4 cable to the whiteboard
3. Attach the Pen Tray to the whiteboard
4. Connect the MOD4 cable to the Pen Tray
The series of steps involved in each of these activities is described in
detail below.
Step 1: Attach the Pen Tray brackets to the Pen Tray
1. Place the Pen Tray topside down on a flat surface.
2. Using the Robertson screwdriver supplied, remove all four
Robertson screws from the underside of the Pen Tray.
3. Lay the flat side of the brackets on the back of the Pen Tray.
SMART Board Installation Guide