Mounting the Pen Tray on the Wall
When your interactive whiteboard is in place, you need to attach the pen tray to the wall.
To perform this procedure, you'll need the following items from the accessory kit:
•
five E-Z insert drywall anchors
•
five No. 8 × 1 1/4" screws
•
the pen tray, with its wall-mount bracket and the IR receiver attached (they're inside a bag for
protection from electrostatic discharge)
•
the USB adapter or 20' (6.1 m) serial cable (if you ordered it)
•
the wireless keyboard
•
four pens
•
the eraser barrier and the eraser
You'll also need a Phillips No. 2 screwdriver (not supplied).
To mount the pen tray
1. Using a Phillips No. 2 screwdriver, insert the drywall anchors into the marked locations. You
made these marks when you were creating the wall opening for the cables.
NOTE: The marked locations probably won't be at the wall studs. However, if they are, you
can use a No. 8 × 1 1/2" wood screw (not supplied) or a self-drilling metal screw (not supplied)
without a drywall anchor at each location.
2. Partially insert a screw into each of the top three drywall anchors using the Phillips
screwdriver. Leave at least 1/8" (0.3 cm) of the screw protruding, so you can hang the pen tray
mounting bracket.
NOTE: The illustration
is not to scale.
Insert a screw into the top
three drywall anchors.
Leave at least 1/8" (0.3 cm)
of the screw protruding.
14
Installing Your Interactive Whiteboard
Wall Opening for Cables
99-00479-03 REV B0