The Pen Tray And The Control Panel - Smart Technologies SMART Board 4000i Installation Manual

The Pen Tray and the Control Panel

The pen tray contains the following tools:
• the eraser, for removing electronic ink
• four styluses, for creating different colored annotations in electronic ink over any
application
• two pen tray buttons, one to activate the SMART Keyboard and one to create a
right-click
• the control panel
You can customize any of these tools with SMART Board software.
NOTE: The 4000i comes with styluses that have black tips, which are better detected by the
digital cameras than any other kind of stylus. If you need to purchase a different stylus, choose
one that has a dark tip.
Eraser
Styluses
The control panel contains:
• a Display Source button for changing the input source (see page 45)
• light emitting diodes (LEDs) that indicate the active display source (see page 43)
• buttons for adjusting the volume of the internal sound system for each source (see
page 43)
• buttons for adjusting the visual display for each source (see page 44)
• an LED for indicating the state of the projector's lamp (see page 43)
• a button for putting the projector into standby mode (see page 41 and page 48)
Display Source Button
Active Display Source LEDs
Pen Tray Buttons
Control Panel
Figure 2: The Pen Tray and the Control Panel
Getting to Know the 4000i
Controls for Volume, Brightness and Contrast
Lamp Status LED
Projector Standby
Button
Instructions
3