Inserting The Mini Rj11 - Smart Technologies Smart Board Installation Instructions Manual

Hide thumbs Also See for Smart Board:

Table of Contents

Inserting the Mini RJ11 Connector into the Whiteboard

3. Insert the mini RJ11 connector into the mini RJ11 socket on the

underside of the whiteboard.

Step 3: Attach the Pen Tray to the whiteboard

1. Remove the two Robertson screws from the rear of the

whiteboard (located on the bottom edge).

2. Place the angled side of the Pen Tray bracket over each screw

hole, then replace the screws and fasten loosely.

NOTE: If the screws do not align correctly with the holes, loosen

the bracket screws on the underside of the Pen Tray, align the

holes, and then tighten the bracket screws again.

SMART Board Installation Guide

mini RJ11 socket, on

underside of whiteboard

bezel

mini RJ11 connector

Table of Contents