Initialization - Panasonic KR20 User Manual

5.9 Initialization

When you'd like to return the inner memory to default setting at factory shipment, initialize it.
After initialization, in master, slave registration and routing setting information data will be deleted.
And in slave, its Unit No. setting, registered, is deleted.
Setting of wireless unit
Operating mode switch
Communication channel
Unit No. switch
MODE switch
※1: At initialization, it doesn't communicate by wireless. Therefore any communication channel
setting is OK.
Procedures for initialization
(1) Set all switches as above.
(2) Turn power supply of wireless unit to initialize on.
(Blinking "ALARM" means it is the state to prepare for initialization.)
Master
Lighting Lighting
(3) Press <ENTER> switch continuously (approx. 3 sec).
( 4) LED is blinking as below.
Master
Lighting Lighting Blinking Blinking
(5) Initialization is completed when LED lights as below.
( Blinking "ALARM" means that MODE switch No.9 is kept to ON.)
Master
Lighting Lighting Lighting Blinking
(6) After completing the initialization, be sure to set MODE switch No.9 to OFF. After that, turn
power supply on again or change operating mode switch.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Be sure to set to "SET".
Select from "00～F5". ※1
Any settings are OK.
Be sure to set No.9 ON. Except it, any settings are
OK. Refer to <3.2.4 Setting of MODE switch>
Slave
Blinking
Slave
Slave
Lighting Blinking
Lighting Blinking Blinking
Lighting Lighting Blinking
5-39