N Topology For Report" Using Example 1 - Panasonic KR20 User Manual

5.8.2 "1:N topology for report" using example 1

This is the example using master's output terminal and slave's input terminal.
Set master to "[I/O] 1:N topology for report" by using setting tool.
●Report system of central display for alarm by 4 type of equipment, that output numbers are
different.
Alarm Display
LMP1
LMP2
LMP3
LMP4
Routing setting of above system by setting tool
In the above system, slave's one input terminal should be connected only 1 point as below table.
"-" shows that it is not connected. For example, only ERR11 of slave 01 is connected input 0. Like
this case 2 or more inputs should not be connected to same terminal, any other allocation is OK.
If all slaves have only 1 input, max 8 slaves's input information can be output from master.
Terminal
Output
Notes: ・In order to transfer input to the other unit, signal should be input over polling time.
・When signal is input to slave, it reflects to master at polling timing.
It delays for polling time.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
LMP5
LMP6
LMP7
LMP8
Master 00
Output terminal
Slave 04
Input terminal
Master 00
0 LMP1
1 LMP2
2 LMP3
3 LMP4
4 LMP5
5 LMP6
6 LMP7
7 LMP8
Slave 01
(Repeater)
Alarm output
Input terminal
from equipment
ERR11
From
equipment
Alarm output ERR41
Alarm output
ERR42
Alarm output
ERR43
Terminal Slave01
0 ERR11
1 -
2 -
3 -
Input
4 -
5 -
6 -
7 -
From
equipment
Slave 02
Alarm output
Input terminal
Alarm output
From
equipment
Alarm output ERR31
Alarm output
ERR33
Slave 03
Input terminal
Slave 02 Slave 03 Slave 04
- -
ERR21 -
ERR22 -
- ERR31
- ERR32
- - ERR41
- - ERR42
- - ERR43
ERR21
ERR22
-
-
-
-
-
5-35