Flow To Introduce; Flow To Introduce "1:1 Topology - Panasonic KR20 User Manual

3.1 Flow to introduce

Examine
communication
Setting wireless unit
(Initial setting)
(Slave registration)
(Routing setting)
Communication test
Introduction

3.1.1 Flow to introduce "1:1 topology"

Initial setting of
master and slave
Slave registration
Operation during
3-2
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Examine about communication system such as communication style
(1:1 topology, 1:1 topology with repeaters, 1:N topology), number of
connected equipment, layout and so on.
system
Consider the communication data amount, response time and
mounting conditions at the same time.
According the examined result, set wireless units to be required.
(Read chapter 3 to chapter 5.)
When introducing 1:1 topology, it's set by only the main unit.
When introducing 1:1 topology with repeaters or 1:N topology, it's set
by using setting tool.
After completing all settings, proceeds the communication test by
using each test functions in setting tool. (Read chapter 6.)
If the communication test is good, proceed test operation with the
actual equipment.
Set Unit No., communication channel and MODE switches.
For 1:1 topology, No.1 of MODE switch should be set to OFF.
Reference: <3.2 Initial Setting of Wireless unit>
Register slave at the master. Slave's Unit No. should be registered as
"01". When operating mode switch is set to RUN, it can communicate.
Reference: <Chapter 4 Register Slave>
Set as the actual running conditions.
running
Reference: <5.2 Setting and operation of "1:1 topology">