Change Routing Setting; Modify Slave Unit - Panasonic KR20 User Manual

5.5 Change routing setting

This is the explanation about changing routing setting at 1:1 topology with repeater and 1:N
topology.

5.5.1 Modify slave unit

(1) Click one slave to modify in routing table and select "Routing setting" -> "Slave unit
setup" -> "Modify".
You can modify slave's Unit No. and name.
Select from 01 to 99 for Unit No.
For naming, it is possible to use alphabet and numbers up to 8 letters.
For example, "slave3" will be modified to "SLAVE3".
Click 'OK' and "slave3" is modified to "SLAVE 3" in lower right of master.
Initial asterisk (＊) of name means that it is not reflected to master unit.
"(3)" after name means Unit No. 3. Sharp (＃) indicates that terminal is not set. (After entering
terminal, ＃ is cleared and after completing transfer to master and transfer from master, ＊ is
cleared.)
5-18
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net