Table of Contents
Advertisement
5.3.2 Routing setting
(1) Connect computer and master with RS232C cable.
(RS485 type: MODE switch No.2 is set to OFF)
(2) Turn power supply of master unit on with operating mode switch "SET".
(3) Boot setting tool.
Click on the Windows [Start] button and then select "All Programs", "Panasonic-EW Control",
"Configurator", "Configurator KR", and "Configurator KR" on the displayed Windows menu, in
that order.
After selecting and click OK, below window is displayed.
※From the left, there are 3 areas of "Registration list view", "Routing table view" and "Terminal
equipment list view".
Setting of master
(4) Select [Routing Setting]->[Master Unit Setup] in menu to set master.
Master unit setup window is opened.
Input Unit No. and name.
Unit No. is "00" by default.
(but as a matter of convenience, it is possible to change if necessary. However, if set it except for
"00", slave unit should be registered first.)
For naming, it is possible to use alphabet and numbers up to 8 letters.
5-4
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Advertisement
Table of Contents
Troubleshooting
