Table of Contents
Advertisement
(3) Turn power supply of master and slave on.
Master
No.1:OFF
5.3 Setting and operation of
5.3.1 Setting contents
Setting flow
According to the below flow it's set. In this part it is assumed that setting of master and slave, slave
registration are completed. If not yet, refer to chapter 3 and 4 first.
Initial setting of
master/slave
Slave registration
Routing setting
Operation
during running
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Same communication channel
Unit No.:00
Slave
Serial communication selection, baud rate, data length,
parity should be set according to connected equipment.
"1:1 topology with repeaters"
Reference： <Chapter 3 Initial settings>
Reference： <Chapter 4 Register slave>
It is explained in this chapter.
Proceed with "Master unit setup"→"New slave unit"→"Transfer to
Master Unit"→"Transfer From Main Unit".
※For changing methods <5.5 Change routing setting>
It is explained in this chapter.
Unit No.: 01
5-3
Advertisement
Table of Contents
Troubleshooting
