Setting Of Communication Channel; Setting Of Unit No. (Master, Slave); Setting Of Mode Switches - Panasonic KR20 User Manual

Wireless unit

Table of Contents

3.2.2 Setting of communication channel

Select the communication channel from "00～F5".

Adding to the fixed channel, 76ch(00～４B), 89 group channel can be selected.

Group channel is the function that it selects connectable channel from several fixed channels

automatically. When using repeater function, use with the fixed channels.

When using group channel, settable channel numbers are decreased in the same communication

area and the communication time is longer.

Master, slaves, repeaters in the same wireless system should be set to the same channel.

Setting of communication channel will be available when turning power on again or changing

operating mode switch.

Note： When using several channels in the same communication area, check there are no

influences each other. It differs from the mounting conditions; max 15 channels are

used as a standard. Do not use adjoining channels and use channel that separates

5 or more (recommended).

Set Unit No. for master to "00", for slaves and repeaters to "01～99".

With 1:1 topology, be sure to set it for slave to "01". If not, it cannot communicate.

Note: Within the same wireless system (same master), do not set the same Unit No. for

several slaves. In addition, there is the function to prevent double registration for

slave. (Slave double registration) Refer to <4. Register slave> in detail.

・ When setting of 1:1 topology, you can use as same as the setting during operation.

・ When setting of 1:1 topology with repeaters or 1:N topology, select RS232C for serial

communication selection. It is required to use setting tool.

Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net

※At factory setting, it's set to "00".

※At factory setting, it's set as left figures.

Set the setting of available/not available by 1:N topology setup, switch

RS232C/RS485, Available/Not available of data holding, communication

conditions.

3-5

Table of Contents